Created with Sketch.

Diamond Glass Densifier

(No reviews yet) Write a Review
Diamond Glass Densifier

 Densifier For Concrete

Universal Polishing Systems 35-DGND100/500/5500 Lithium NANO Densifier is an eco-friendly, impregnating densifier/sealer specifically designed to be used in the polishing of natural and cementitious surfaces. It is a concentrated formula and dilutes with water. It can be used in both interior and exterior applications. The 35-DGND100/500/5500 penetrates and protects the surface without affecting its natural appearance. The polishing application increases the abrasion resistance while increasing the resistance to freeze/thaw scaling, efflorescence, spalling, staining, mildew and fungi, and water intrusion. The enhanced penetration of the NANO particles with the NANO glass beads provide extended life, higher abrasion resistance with lower maintenance requirements, reduced cleaning costs and repairs while achieving an extremely high degree of reflection. It forms a dense, breathable, surface that will not flake or peel. The natural reaction of the lithium with the lime/calcium of the cement close off most of the fine capillaries in the concrete creating a highly dense, hard surface and greater light reflection.


Universal Polishing Systems 35-DGND100/500/5500 Lithium NANO Densifier can be used over stucco, granite, natural stone, limestone, terrazzo, decorated concrete and any material made with Portland cement as a binder. Typical applications include concrete, polished concrete or stone flooring, countertops or any porous surface, natural stone or cementitious product, requiring added protection or reflectivity.

Surface Preparation

Ensure the substrate is dry and free of all foreign materials such as curing agents, laitance, glaze, efflorescence, dust, dirt, oil, grease, curing compounds, etc. that may impair or prevent penetration or bonding.


Universal Polishing Systems 35-DGND100/500/5500 Lithium NANO Densifier may be applied by spray, roller or brush. NOTE: Be sure to mix, stir or shake thoroughly before applying. As a guard/sealer for polished concrete it is best applied with a pump type sprayer and applied with a microfiber floor applicator. Mix the product with 4 parts water to 1 part 35-DGND100/500/5500 Lithium NANO Densifier (one gallon container makes 5 gallons of densifier). Surface should be evenly saturated. Do not allow liquid to puddle. Depending on surface porosity, climate and temperature, dry time can be as much as 2 hours.

Once treated, the surface can take foot traffic after 2 hours. The surface will continue to harden over time, reaching its maximum durability and resistance over approximately 7 days.

Use water to clean tools or equipment, no special or hazardous disposal methods are necessary.


Do not apply when temperatures are below 40º F or above 100º F. In hot, dry, or windy conditions, you may consider lightly dampening the surface.

Technical Data

Coverage can vary from surface to surface depending on roughness, porosity and density of the medium being applied. Application technique can also vary the coverage. On smooth, dense surfaces, the coverage should generally range from 400 to 800 square feet per gallon when properly diluted.


  • Dry Time: 1 to 2 Hour 
  • Color: Clear
  • Freeze Point: 32˚F, do not allow to freeze 
  • V.O.C.: 0 lbs per gallon
  • Shelf Life: 1 year in sealed container
  • Flash Point: N/A
  • Solids: Approx. 18%