Created with Sketch.

Stone Tech High Gloss Finishing Sealer

(No reviews yet) Write a Review
Calculated at Checkout
Stone Tech High Gloss Finishing Sealer

High Gloss Sealer By Laticrete

High Gloss Sealer is made by Laticrete formerly known as Stonetech or Dupont. The penetrating sealer gives the floor a wet look or high gloss look. This high gloss sealer not only seals and protects the stone or concrete, but leaves it with a unique look many customers perfer.


Features and Benefits of High Gloss Sealer

  • Two-in-one formula leaves a wet-look finish and protects against stains
  • Easy-to-use, water-based formula
  • Interior use

Where to Use

  • Slate, saltillo, limestone, travertine and concrete floors.
  • Not intended for use on glazed, polished, or non-absorbing surfaces, wood floors and decks, showers, countertops, or near pool areas.


Product Information

  • Packaging Sizes: Quart, Gallon, 5 Gallon, 55 Gallon
    • Quart: 25-75 sq ft
    • Gallon: 100-300 sq ft
  • Part of System: StoneTech®



Read entire label before using. Use only as directed. Always test in a small inconspicuous area to determine appropriate application method, achievement of desired results, and to ensure good adhesion. Ensure work area is well-ventilated during application and until surface is dry. Keep children and pets out of the area until foot traffic resumes. Avoid applying in direct sunlight. Surface must be thoroughly clean, dry, and free of any sealers or coatings before application. Application to a dirty or dusty surface will affect adhesion and appearance. High Gloss Finishing Sealer should not be applied to a wet or moist surface. Avoid applying onto surfaces not intended for treatment. For new installations, sealer can be applied as soon as 48–72 hours after grouting. Fresh concrete slabs require a minimum of 28 days to cure before applying the sealer.

Liberally apply 2 to 4 even coats with a natural bristle brush, roller, or paint pad applicator. Do not apply product with a sprayer or sponge. Avoid puddling of liquid during application. Failure to apply a sufficient amount of sealer to the surface may result in an undesirable finish or degradation of the coating. More coats may be applied if desired.
Allow 30–45 minutes between coats or until surface is dry to the touch.
Surface traffic may begin 12 hours after final application; keep installation dry for a minimum of 12 hours; full cure is achieved in 24–48 hours.
Keep surface clean and dry as finished surfaces may become slippery when wet.
Available Sizes (and Coverage)