RepCon V/O Single Component Polymer-Modified Concrete Repair Mortar (Pack of 6)
RepCon V/O Single Component Polymer-Modified Concrete Repair Mortar (Pack of 6) is backordered and will ship as soon as it is back in stock.
Safe & Secure Payments
RepCon V/O Single Component Polymer-Modified Concrete Repair Mortar (Pack of 6) is backordered and will ship as soon as it is back in stock.
Product Description
RepCon V/O is a fiber-reinforced concrete repair mortar for horizontal, vertical, and overhead repairs, with a corrosion inhibitor built in
RepCon V/O is a single-component, polymer-modified mortar for industrial, commercial, and infrastructure/DOT repair applications. It's hand- or spray-applied and holds up to 2 inches thick per lift.
Key Features & Benefits
- One-component, dry polymer-modified — just add water
- Fiber-reinforced for strength and freeze-thaw durability
- Can be hand-applied or spray-applied for large projects
- Cures to a concrete-gray color
- Formulated for vertical and overhead repairs
- Contains an integral corrosion inhibitor to protect rebar
Application Instructions
-
- Cleaning the Surface: Ensure the concrete is sound, and free from oil, grease, dust, laitance, or other contaminants. Saw cut the perimeter of the repair area 1/8” deeper than the repair depth to create a notched, reinforced edge.
- Abrasive Preparation: Mechanically abrade the surface to a minimum Concrete Surface Profile (CSP) of 5, in line with ICRI 310.2 guidelines. All concrete surfaces must be saturated-surface-damp (SSD) with no standing water present.
- Steel Reinforcement Treatment: Clean all exposed steel reinforcement of rust and coat with SpecPrep SB. Apply a spray or brush coat of SpecPrep SB to SSD concrete, proceeding with the repair mortar application wet on wet or within the recommended open time as per the SpecPrep SB datasheet.
Mixing and Application
- Mixing Procedure: Mix 6.25 to 6.75 pints of clean water per 50 lb bag of RepCon® V/O, adjusting for desired consistency. Use a low-speed drill for mixing, starting with water then gradually adding the RepCon® V/O. Mix for 2 to 3 minutes until homogenous.
- Application Instructions: For placement, trowel RepCon® V/O firmly into the prepared area ensuring full contact with the bonding surface. Overfill slightly and shape roughly during placement.
- Shaping: After the initial set when RepCon® V/O is surface hard, shave the material to the final shape using a steel trowel. The maximum depth of neat repair mortar is 2” per lift; additional lifts can be applied after the initial set ensuring the original lift has a rough surface to enhance bond between lifts.
Finishing and Curing
- Finishing: Finish the repair material to match the surrounding concrete texture. RepCon® V/O is self-curing under most conditions but in severe drying conditions, an ASTM C309 compliant water-based SpecChem curing compound should be used.
- Curing: Moist curing is recommended immediately after finishing and should continue for 48 hours. Protect newly applied material from rain, sun, and wind until compressive strength is 70% of the 28-day strength. Cover with insulating material to prevent freezing. Setting time is dependent on temperature and humidity.
Technical Data Summary
- Set Time (70°F, ASTM C266): Initial set 50 minutes, final set 90 minutes
- Compressive Strength (ASTM C109): 3,650 psi at 1 day, 7,450 psi at 28 days
- Shelf Life: 12 months unopened, stored in a cool, dry location away from direct sunlight
Packaging
Available in 50 lb bags (pack of 6).


