Kenco Hardrock Buckets are made in the USA and include Cleanup Buckets, Ripper Buckets, Extreme Service Buckets, Twist a Bucket, Trapezoidal, and V Bottom Buckets

THE TOUGHEST BUCKETS IN THE INDUSTRY ARE FOUND AT KENCO!

HARDROCK BUCKETS FEATURE:

  • Double Sidewall Construction
  • AR 400 steel construction
  • Choice of teeth: ESCO, CAT, Hensley
  • Tapered Design (allows the bucket to dump its content efficiently)
  • Deep profile offers extra capacity in a rock excavator bucket

ROCK RIPPING BUCKETS ARE BUILT STRONGER THAN MOST OTHER "EXTREME DUTY" BUCKETs

KENCO HARDROCK AND SPECIAL PURPOSE BUCKETS ARE AVAILABLE IN ABSOLUTELY ANY SIZE AND TYPE. KENCO BUCKETS OFFER THESE ADVANTAGES:

  • T1 lugs with hardened Line-bored bushings
  • Heavy duty corner gussets
  • High strength abrasive resistant leading side edges
  • Hardened abrasive resistant cutting edges
  • Heavy duty teeth and adapters
  • Extra large high strength triangular torque member
  • Dual radius double rolled shell
  • Rolled backplate
  • Standard lifting eye

RIPPER BUCKET

Cuts quickly through hard soil conditions and withstands intense digging requirements. Rock teeth extend below the bucket to rip hard soil, rock or shale. This allows the operator to load the bucket and loosen the next layer at the same time.

EXTREME SERVICE BUCKET

Designed and built for digging in extreme terrain. The extra heavy duty construction optimizes the machines breakout and crowd forces which reduces cycle times. Buckets come equipped with abrasion-resistant cutting edge, drilled for side cutters, high strength abrasion resistant side edges and corner bits. For additional durability you can opt for a T-1 liner and hard surfacing.

TRAPEZOIDAL BUCKET

Heavy construction and available in drop center configurations. Standard sizes range from 18 x 60 to 42 x 84 inches. These buckets come with a either a bolt on edge or teeth. Custom configurations are available.

V-BOTTOM BUCKET

The V shaped design gives this bucket unprecedented penetration to dig through frost, shale, or rock. Heat treated alloy construction gives superior strength and wear in the roughest of conditions

TWIST-A-BUCKET

Features a 45 degree tilt both left and right. Excellent versatile tool for sloping banks for grade, ditch cleanup, and contour sloping. Available in sizes from 48 inches to 96 inches and of .5 to 4.25 cubic yards.

CLEANUP BUCKET

Open design for easy clean-out, the excavator cutting edge is drilled for bolt-on edge. Available in sizes from 48 to 96 inches width and of 7/8 to 5 7/8 cubic yards.