Diamond Glass Sealer/Guard for Concrete

Sale on Water Based Diamond Glass Sealer/Guard for Polished Concrete

Series 35 - Diamond Glass Sealer
Description
The 35 Series Diamond Glass Sealer is an eco-friendly, impregnating sealer/guard specifically
designed to be used in the polishing/sealing of natural and cementitious surfaces. It can be used in both
interior and exterior applications. The water-based Diamond Glass Sealer penetrates and protects the surface
without affecting its natural appearance. The polishing/sealing application of this sealer for concrete increases the abrasion resistance while increasing the resistance to freeze/thaw scaling, efflorescence, spalling, staining,
mildew and fungi, and water intrusion. The enhanced penetration capability with the NANO glass beads provides extended life, higher abrasion resistance with lower maintenance requirements, reduced cleaning costs, and repairs while achieving an extremely high degree of reflection. The water glass sealer forms a dense, breathable, surface that will not flake or peel.

Uses
The 35 Series Diamond Glass Sealer can be use over stucco, granite, natural stone, limestone,
terrazzo, decorated concrete and any material made with Portland Cement as a binder. Typical
applications include concrete, polished concrete or stone flooring, countertops or any porous surface,
natural stone or cementitious product, requiring added protection or reflectivity.
Surface Preparation
Ensure the substrate is dry and free of all foreign materials such as curing agents, laitance, glaze,
efflorescence, dust, dirt, oil, grease, curing compounds, etc. that may impair or prevent penetration or
bonding.
Application
The 35 Series Diamond Glass Sealer may be applied by spray, roller or brush. NOTE: Be sure to stir
or shake thoroughly before applying. As a sealer/guard for polished concrete it is best applied with a
pump type sprayer and applied with a microfiber floor applicator. Surface should be evenly covered. It
is better to apply two light coats rather than one heavy coat. Once the Diamond Glass Sealer has dried
and cured (roughly 1-2 hours), the surface should be burnished with a high speed (1500 RPM or
higher) burnisher with a 40 Series Hurricane Pad. Depending on surface porosity, climate and
temperature, dry time can be as much as 2 hours.
As a topical sealer, a low pressure or HVLP sprayer is advised in order to keep a more uniform coat.
Once treated, the surface can take foot traffic after 2 hours. The surface will continue to harden over
time, reaching its maximum durability and resistance over approximately 7 days.
Use water to clean tools or equipment, no special or hazardous disposal methods are necessary.
Limitations
Do not apply when temperatures are below 40° F or above 100° F. In hot, dry, windy conditions, you
may consider lightly dampening the surface prior to applying Diamond Glass Sealer.

Technical Data:
Packaging
1 Gallon Pail
5 Gallon Pail
55 Gallon Drum
Coverage
Coverage can vary from
surface to surface
depending on roughness,
porosity and density of
the medium being
applied. Application
technique can also vary
the coverage. On smooth,
dense surfaces, the
coverage should generally
range from 1500 to 3000
square feet per gallon.
Specifications
Dry Time: 1 to 2 hours
Color: Milky White, dries
clear
Freeze Point: 32°F, do not
allow to freeze
V.O.C.: 0 lbs per gallon
Shelf Life: 1 year in
sealed container
Flash Point: N/A
Solids: Approximately
18%