Cobble Coat High Solids

Cobble Coat High Solids is a crystal clear, solvent-based sealer designed to protect and beautify brick pavers, concrete floors, and Texture Deck. 

Providing an enhanced, wet look appearance with semi-gloss finish, Cobble Coat High Solids is made from 100% acrylic resins and is higher in solids than most conventional concrete sealers. Cobble Coat High Solids provides water and UV light resistance with unusually good adhesion to a variety of substrates. Cobble Coat High Solids is recommended for application by contractors only.
 
Each gallon of Cobble Coat High Solids will cover approximately 200 square feet per coat; the 5 gallon container of Cobble Coat High Solids will cover approximately 1,000 square feet. Coverage will depend on surface porosity, joint width and method of application. Second coat will take slightly less product.

Directions

Surfaces must be clean and dry before sealing. All grease, oil and potential contaminants must be removed.

Concrete should cure a minimum of 28 days before sealing.

Interlocking brick does not require etching.

Cobble Clean and Cobble Prep may be used for specific cleaning situations. Two thin coats provide the best results. 

Do not apply Cobble Coat more frequently than every 18 months to avoid buildup of the sealer.

DO NOT thin material. Future applications should be applied in only one thin coat.

Cobble Coat High Solids is recommended for application by contractors only.

COBBLE COAT HIGH SOLIDS IS NOT RECOMMENDED FOR USE ON SURFACES WHERE MOISTURE IS UNABLE TO DISSIPATE.

READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT.

Technical Sheets

SDS Sheet