Lithium Silicate Diamond Glass NANO Densifier

The 35 Series Diamond Glass Densifier is an eco-friendly, lithium silicate-based impregnating densifier designed for use in polishing natural and cementitious surfaces. This concentrated formula is water-dilutable and suitable for both interior and exterior applications.

It penetrates deep into the concrete surface without altering its natural appearance, creating a harder, denser, and more reflective floor. When used as part of a polishing system, it improves abrasion resistance and enhances protection against freeze/thaw damage, efflorescence, spalling, staining, mildew, fungi, and water intrusion.

The advanced nano glass bead technology enhances penetration, durability, and long-term performance while reducing maintenance and cleaning costs.

Key Benefits

• Increases surface hardness and abrasion resistance
• Enhances gloss and light reflectivity in polished concrete
• Reduces staining, dusting, and surface wear
• Improves resistance to freeze/thaw scaling and moisture intrusion
• Eco-friendly, low VOC formula
• Will not flake, peel, or yellow over time
• Breathable, long-lasting surface protection

Recommended Uses

Suitable for a wide range of cementitious and natural stone surfaces, including:

• Polished concrete floors
• Terrazzo
• Granite and natural stone
• Limestone
• Stucco
• Decorative concrete
• Countertops and other porous cement-based surfaces

Ideal for any application requiring increased hardness, durability, and reflectivity.

Surface Preparation

Ensure all surfaces are:

• Clean, dry, and free of contaminants
• Free from curing compounds, dust, oil, grease, efflorescence, and laitance
• Properly prepared to allow full penetration and bonding

Application Instructions

The 35 Series Diamond Glass Densifier can be applied using a sprayer, roller, or brush. For polished concrete applications, a pump sprayer and microfiber applicator are recommended.

Mixing Ratio

• Mix 4 parts water to 1 part densifier
• One gallon produces approximately 5 gallons of ready-to-use solution

Application Steps

• Apply evenly to saturate the surface
• Do not allow pooling or puddling
• Allow to dry for 1–2 hours depending on conditions
• Surface may accept foot traffic after approximately 2 hours
• Full curing and maximum hardness develop over ~7 days

Tools can be cleaned with water—no hazardous disposal required.

Coverage

Coverage varies based on surface porosity, texture, and application method.

• Typical range: 400–800 sq. ft. per gallon on smooth, dense surfaces

Limitations

• Do not apply below 40°F or above 100°F
• Avoid application in extreme wind or hot, dry conditions without pre-dampening surface
• Do not allow product to freeze (32°F freeze point)

Technical Data

• Packaging: 1 Gallon, 5 Gallon, 55 Gallon Drum
• Color: Clear
• Dry Time: 1–2 hours
• VOC: 0 lbs/gallon
• Shelf Life: 1 year (sealed container)
• Solids: ~18%
• Flash Point: N/A

Coefficient of Friction (800 grit polish average)

• Wet: 0.688
• Dry: 0.840