Note: Hazardous chemicals must be shipped via UPS Ground. All other shipping options will be removed from checkout if added to cart. If you need expedited services for non-hazardous products, please make a separate transaction.

A clear acrylic water base finish designed to protect and beautify slate, flagstone and quarry tile.

Protects against all organic stains including cooking oil, grease and beverages. UV resistant. It may be used indoors or outdoors and is extremely easy to apply and maintain. It is LEED eligible.

• Water base
• Low gloss / film forming
• Ideal for denser stone & brick
• Protects from stains, oil and grease
• Non-yellowing
• Efflorescence resistant
• Low VOC formula

SDS Sheet

Fact Sheet

USES • Waterseals, protects and improves appearance of all slate, flagstone and quarry tile. • Use indoors and outdoors. • Low sheen appearance eases clean up. • May be used as grout release.

FEATURES • Repels oil and grease stains • Nonflammable • No harmful vapors • Cleans up with water • Easy to apply • Water repellent • Reduce efflorescence • Recoatable • Non-yellowing

PREPARATION All surfaces must be free of efflorescence, dirt, oil, wax, grease and defective paints or sealers. If muriatic acid is used, all acid residue must be removed prior to application of sealer. Do not allow acid to dry. Use Glaze ’N Seal Neutralizing Rinse to neutralize surface before sealing.

STORAGE: Do not allow to freeze.

APPLICATION Apply two or more coats of sealer (do not allow it to puddle). Make sure each coat is dry to the touch before applying second coat; usually one to two hours. Allow additional drying time in moist, cool climates. It can be applied with a sponge mop, lambs wool applicator or spray-equipment dependent on porosity and roughness of surface. Clean tools with water before sealer dries.Apply between 55ºF and 80ºF. If it is necessary to apply sealer on a warm day in direct sunlight, slightly dampen the surface to be sealed with a fine spray of water prior to application of the sealer. Allow 72 hours curing time against heavy moisture and bulk water. Sealer will continue to gain strength for up to one week. Note: Always test a small area of surface to be sealed to verify penetration and satisfaction of sealed appearance.

COVERAGE 100 to 600 square feet per gallon depending on the porosity of the surface.

MAINTENANCE Glaze ’N Seal Floor Polish is recommended as a protective finish over the sealer (indoors only).This will protect the sealer and extend sealer life significantly. Sweep and damp mop floor frequently.Use Glaze ’N Seal Neutral Cleaner to clean floor as necessary.

PACKAGING Concrete,Tile and Masonry Sealer is packaged in quarts, gallons, 5 gallons and 55 gallon drums.