SC Concrete Finish is a decorative, cement-based resurfacing mortar for smoothing, resurfacing, and restoring concrete, and doubles as a breathable waterproofing coating
SC Concrete Finish resurfaces, rubs, sacks, and restores concrete surfaces, and can also serve as a waterproofing coating for vertical concrete and masonry substrates. It creates a uniform, water-resistant surface that fills voids while remaining fully breathable, and works as a consistent alternative to traditional jobsite sacking mixes.
Key Features & Benefits
- Waterproof barrier for interior/exterior, above/below grade applications on masonry and concrete
- Applies to concrete block, brick, stone, precast, or formed concrete
- Consistent texture and uniform color
- Fully breathable finish
Application Instructions
- Ensure the surface is structurally sound, clean, and free from dirt, release agents, and efflorescence
- Mix mechanically with a slow-speed mixer for about 3 minutes, without over-mixing
- Add roughly half of the required 5 quarts of liquid first, then gradually add the SC Concrete Finish powder and chosen admixture (water or StrongBond) to a heavy pancake-batter consistency
- Let the mix rest 3 minutes to "fatten," then remix and adjust consistency as needed
- Brush-applied: use a 6-inch cement mason's brush with long, smooth horizontal strokes; finish all final strokes in one direction for an even texture
- Spray-applied: mix with 10-12 pints of liquid using plaster or low-pressure spray equipment